Metric Fittings,Copper Fittings,Brass Bsp Fittings,Hydraulic Din Fittings Jiaxing Master Fitting CO.,LTD , https://www.jiaxingmaster.com
The wear of the gear is generally due to the failure of the lubricating oil and the cleaning of the surface of the gear to prevent the surface of the toothed table from being worn or even changing the structure of the gear. The gap is increased so that the teeth become thin and broken due to excessive wear.
At the beginning of the gear operation, the wear of the gear is inevitable, and the wear will make the surface of the gear smooth, and there is no surface scratch and wear. Because the gear is exposed to the air for a long time, it will be attached to the surface. The water will be oxidized to cause rust on the surface and increase wear. This damage is not only on the surface, it makes the gears soft and can't be used.
The gluing of the two tooth surfaces of the gear is because the gear is too thick to make the two tooth surfaces directly thick, and the gear teeth of the gear are metal. After the glue, the gears need to run. The gear will be worn and the metal on the surface will fall. When the Zhangjiagang mill or even one tooth drives the other tooth to rotate, the teeth will be deformed and damaged. This is a serious wear phenomenon.
This kind of wear is an irreparable new gear that will also be glued at the beginning, but this is normal, but such wear will make the gear surface bright, this wear is inevitable, it will be the operation of the gear More smoothness does not require much attention.