Ultrasonic vibrating screen eccentric block adjustment 1. Weight of eccentric block: increase the weight of the eccentric block (increasing the secondary eccentric weight) to increase the amplitude of the ultrasonic vibrating screen, the lower eccentric block controls the upper and lower amplitude of the sieve machine, and the upper eccentric block controls the left and right amplitude of the sieve machine 2, the angle of the eccentric block: adjust the angle of the eccentric block to control the running track of the material on the screen. The specific adjustment angle can be adjusted according to the specifications of the supplied ultrasonic vibrating screen and adjusted according to the material characteristics. However, there are other reasons that may affect the amplitude in addition to the following: 1. Ultrasonic vibrating screen vibrator damage: The shock wave generated by the ultrasonic vibrating screen is realized by an ultrasonic generator. The ultrasonic generator is mainly realized by a vibrator. Damage to the vibrator or cracking of the vibrator during use can result in too small a vibration frequency. Users can directly send the vibrator back to the manufacturer for repair. 2. There is a gap in the bottom of the ultrasonic vibrating screen: this phenomenon is caused by the long time of use of the screen machine, causing gaps in the bottom plate and causing short circuit. Users of this problem can contact the manufacturer for repairs; 3, ultrasonic vibrating screen material problem: because some ultrasonic vibrating screen manufacturers use the thinner material for the most profit-seeking. When the vibration frequency is too large, the sieve machine is broken. Users should choose carefully when purchasing the screen. You should not only focus on the price but ignore the quality of the screen itself. Ozone Generator,Ozone Generator India,Ozone Generator Portable,Ozone Air Purifier Generator Leeyo Pilot Electric Technology Co., Ltd , https://www.nbleeyo-pilot.com
Reasons for the low frequency of the ultrasonic vibrating screen
The adjustment of the amplitude of the ultrasonic vibrating screen is related to the yield and accuracy of the material screening. The amplitude can be adjusted from low to high in three stages. Low amplitude: mainly used for materials with heavier specific gravity, materials with good fluidity, no need to make materials jump very high; medium amplitude: mainly for screening with general materials, not only for materials Blocking the net does not allow the material to jump very high; high amplitude: mainly the application and the material is lighter in weight, the viscosity is very large, there is static electricity and other materials, so that the material does not stick, the material is broken up by the high amplitude of the ultrasonic wave, thereby Screening of advantageous materials.