Ningbo Hengnuo Hydraulic Drive Co.,Ltd , https://www.hnhydraulic.com
    1. The locomotive driver must follow the signal command to drive. Before driving, the driving signal must be issued. When the locomotive is running, it is strictly forbidden to poke the head or body out of the car. When the driver leaves the seat, the power should be cut off, the control handle should be removed, and the brake should be tightened. However, the lights must not be turned off.
    2. Road signs and warning signs should be installed in the roadway. When the locomotive line is near the crossing, corners, turnouts, slopes, or noise, etc., the construction management of the 1G420000 mining project is 243 , and when there is a problem with the front of the car or the line of sight, it must be decelerated and issued a warning sign.
    3. It is strictly forbidden to use fixed-vehicle type mining vehicles, inverted car-type mining vehicles, bottom-loading mining vehicles, material trucks and flatbed vehicles. When transporting personnel by hand, the train speed must not exceed 4m/s.
    4. When the manual cart is used, only one vehicle can be pushed once. Do not push the cart on both sides. When the track slope is not more than 5%, the distance between the same carts shall not be less than 10m; the slope shall be greater than 5%. When not less than 30m. It is strictly forbidden to have a slope greater than 7%. A human cart is used in the roadway.
    5. When transporting personnel such as steel wire rope belt conveyors, the width of the conveyor belt shall not be less than 0.8m, the running speed shall not exceed 1. 8m/s, and the spacing of passengers shall not be less than 4m. The occupant must not stand or lie on his back and should face the direction of travel.
    (2) Requirements for gas mine transportation equipment
    1. In the main transport lanes where low gas mines enter the wind, overhead electric vehicles can be used, but the roadways must be supported by non-combustible materials.
    2. Mine explosion-proof special battery locomotives or mine explosion-proof diesel locomotives should be used in the main transportation lanes of high gas mines.
    (3) Safety requirements for transport personnel in inclined roadways
    1. The main inclined shafts with a length of more than 1. 5km or the main inclined shafts above and below the personnel with a height difference of more than 50m shall be transported by mechanical means.
    2. The person who transports the personnel in the inclined shaft must have a follower. The follower must sit at the position with the handle of the manual brake and be equipped with a device that can send an emergency signal to the driver at any point during the operation. .
    3. Before each class of transport personnel, the connection device, fuse chain and brake device of the vehicle must be inspected and run once at no load.
Safety regulations for the transportation of alleys and inclined shafts
    (1) General requirements